It does not really show this colour off to its full but gives you an idea!!!!

Changes in different lights with the pearl effect. It is BRIGHT!!!!!! You won't miss seeing this at an event

Scuttle being fitted

Scuttle with riv-nuts and vertical panel

Scuttle in place

All carbon scuttle and panels

Carbon scuttle and dash

Finished front closing plate

And another

Finished side skins

Front top edge of engine bay, finished

Finished seam in engine bay

Finished edges of cockpit

Finishing touches to sill joints

Finished side awaiting wing

Close up of joint

Finished boot edge

Finished top edge of boot

Almost finished boot and back end

Seam of side panel to floor (seat U in back ground). Edge finished for SVA

Another of side skin to floor SVA compliant finish

Under side of back skin to lower boot floor, finished for SVA

Tunnel top support

Front tunnel top being cut to fit before trimming

Rear tunnel top awaiting finishing trim

Pedal box

Footwell closing plates-stop the dirt and leaves getting trapped!!!

And the other side, closing plate for footwell

Painting all the powdercoating with a urethane-acrylic to improve resistance to corrosion and stone chips

Light brackets painted too!

Carbon front wing

Carbon clad chassis ready for building up the kit now

Cockpit, nearly finished but not trimmed

The underside with floor and tank closing floor

Front underside

Rear from underneath, beautiful but I am the only one to see it!!!

Tank sandwich floor and turrets

Another view of the almost finished cockpit

Finished side skin

The underside